Introduction
Water Charges are levied for metered connections based on consumption. The rate for calculation of water charges can vary varies widely and can be is dependent upon various parameters. In digit DIGIT W&S module, consumption water charges defined are based on actual consumption combined with and property usage type.
Data Table
Sr. No. | *Property Usage Type | *Water consumed value from (units) | *Water consumed value to (units) | *Rate (in Rs/ unit) |
|---|---|---|---|---|
1 | Residential | 1 | 150 | 3 |
2 | Residential | 151 150 | 300 | 4 |
Note: Data given in the The above table is a contains sample metered water rates data.
Procedure
Data Definition
Sr. No. | Column Name | Data Type | Data Size | Mandatory | Description |
|---|---|---|---|---|---|
1 | Property usage type | ReferenceAlphanumeric | 64 | Yes | Refer Usage Category Major |
2 | Slab (Water consumed )value from | Decimal | (5,3) | Yes | From and to value for water consumed |
3 | Water consumed value to | Decimal | (5,3) | Yes | To value for water consumed |
34 | Rate | Decimal | (3,3) | Yes | Consumption charges per unit corresponding to the usage type |
Steps to fill data
Download the data template attached to this page.
Get a good understanding of all the headers in the Refer to the ‘Data Definition’ section of this document to learn more about the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.In case of any doubt, please .
Please reach out to the person who has shared this template with you to discuss and clear your doubts
Get information about charges levied for metered connection as a part of bill
Get slab range and rate information for corresponding property usage type
Property usage type collected from State/ULB should be mapped with DIGIT property module
.
Select the property type from the drop-down list available in the Property Usage Type column.
Enter the Slab (water consumed) range details in the From and To Value for water consumed.
Enter the Rate for the specified slab range and property type.
Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.
Checklist
The checklist is a set of activities to be performed one the data is filled into a template to ensure data type, size, and format of data is as per the expectation. These activities have been divided into 2 groups as given below.
Common Checklist
This checklist covers all the activities which are common across the entities.
Sr. No. | Checklist Parameter | Example |
|---|---|---|
1 | Make sure that each and every point in this reference list has been taken care of. |
Entity Specific Checklist
This checklist covers the activities which are specific to the entity.
Sr. No.
Checklist Parameter
Example
1
Property usage type should be mapped to ontology present in property module
‘Domestic’ in W&S = ‘Residential’ in PT
2
Slab (Water consumed) should be a decimal value
1.24 : [Allowed]
1.24 kL. : [Not allowed]Separate Entity Specific Checklist is not required for this module data.