Introduction

There are two reasons for recording the water source. One is to measure availability vs consumption

. And, the other is to monitor the water quality

.

Each ULB captures this information. Hence, the water source details are configurable at the ULB level. ULBs can configure water source data at two levels - water source and water sub source.

Data Table

Note: The table above contains sample water source data.

Procedure

Data Definition

Steps to fill data

1. Download the data template attached to this page.

2. Refer to the ‘Data Definition’ section of this document for more details on data

1. type, size, and definitions.

2. Contact the person who shared this template with you to discuss and clear your doubts.

3. Enter the relevant Water Source.

4. Enter the corresponding Water Sub Source. This will map the water sub source to the specified water source

1. .

2. Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.

Checklist

The checklist is a set of activities to be performed one the data is filled into a template to ensure data entry requirements are met. These activities have been divided into 2 groups as given below.

Common Checklist

This checklist covers all the activities which are common across the entities.

Entity Specific Checklist

Separate Entity Specific Checklist is not required for this module data.

Attachments