Introduction
Sewerage Charges are
...
recurring charges levied for a pre-defined billing period. The billing period is configurable as per the state or ULB requirement. The rate for calculation of sewerage charges can vary widely and
...
is dependent upon various parameters. For
...
instance, they can be dependent either upon
...
plot size slab combined with property usage type or solely dependent upon property usage type. In some cases, sewerage charges can also be levied as
...
a percentage of water charges.
Data Table
Sr. No. | *Property Usage Type |
---|
...
Flat fee (in Rs)
...
...
...
...
...
...
...
Sr. No.
...
Property Usage Type
...
*Calculation attribute | Slab value from (units) |
---|
...
Slab value to (units) |
---|
...
*Charges |
---|
...
1 |
...
Residential |
...
Property Size |
...
1 |
...
...
...
...
150 | Rs 5/ unit | |
2 | Residential | Percentage of water charges (%) |
...
...
...
...
Procedure
Field Description
...
Sr. No. : Defines the serial no of the line item.
...
Property usage type : Specifies the property usage type
...
NA | NA | 10 % | |||
3 | Commercial | Flat fee (in Rs) | NA | NA | Rs 300 |
Note: The above table contains sample data for sewerage rates.
Procedure
Data Definition
Sr. No. | Column Name | Data Type | Data Size | Mandatory | Description |
---|---|---|---|---|---|
1 | Property usage type | Text | 64 | Yes | Refer to property usage type |
2 | Calculation Attribute | Text | 64 | Yes | Depending on the case, calculation attribute can be Property Size value, percentage of water charges or a flat amount. |
3 | Slab (Property size value) | Decimal | (10,2) | Yes | Conditional mandatory. From and to value for |
...
Flat fee: Flat sewerage charges collected based on property usage type
...
property size | |||||
4 | Charges | Decimal | (3,2) | Yes | Depending on the calculation attribute charges can be consumption charges per unit corresponding to the usage type |
...
or a percentage or a flat amount. |
Steps to fill data
Download the data template attached to this page.
Refer to the ‘Data Definition’ section of this document to learn more about the template sheet, data
...
Get information about charges levied for sewerage connection as a part of bill
Get slab range and rate information for corresponding property usage type if applicable
Get percentage value for calculating sewerage charges based on water charges
Property usage type collected from State/ULB should be mapped with DIGIT property module
Validation
Data should be collected at ULB level
...
type, size, and definitions.
Please reach out to the person who has shared this template with you to discuss and clear your doubts.
Select the relevant Property Usage Type from the available drop-down list.
Enter the From and To value for property size to specify the range applicable for the selected property.
Enter the Flat Fee applicable for the selected property and Slab.
Enter the applicable Percentage of Water Charges value. The sewerage charges will be calculated as a percentage of the water charges.
Enter the corresponding consumption Rate per unit.
Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.
Checklist
The checklist contains a set of activities to be performed once the data is filled into a template to ensure data entry requirements are met. These activities have been divided into 2 groups as given below.
Common Checklist
This checklist covers all the activities which are common across the entities.
Sr. No. | Checklist Parameter | Example |
---|---|---|
1 | Make sure that each and every point in this reference list has been taken care of. |
Entity Specific Checklist
Separate Entity Specific Checklist is not required for this module data.
Attachments
...