Introduction
Water source is recorded essentially for There are two reasons for recording the water source. One is to measure availability vs consumption and second is for . And, the other is to monitor the water quality monitoring. This information is captured for each ULB, therefore it should be configurable at that level. Water sources has ontology of two levels, ie Water source and Water Each ULB captures this information. Hence, the water source details are configurable at the ULB level. ULBs can configure water source data at two levels - water source and water sub source.
Data Table
Sr. No. | *Water source | *Water sub source |
|---|---|---|
1 | Ground | Well |
2 | Ground | Hand-pump |
Note: Data given in the above table is a sample The table above contains sample water source data.
Procedure
Data Definition
Sr. No. | Column Name | Data Type | Data Size | Mandatory | Description |
|---|---|---|---|---|---|
1 | Water source | DropdownText | 64 | Yes | Water source major category |
2 | Water sub source | Text | Dropdown64 | NoYes | Water source minor category |
Steps to fill data
Download the data template attached to this page.Get
a good understanding of all the headers in the template sheet, their Refer to the ‘Data Definition’ section of this document for more details on data type, size, and definitions by referring to the ‘Data Definition’ section of this document.In case of any doubt, please reach out to .
Contact the person who has shared this template with you to discuss and clear your doubts.
Get information about the water source
Get information about the water sub source
Map the corresponding Enter the relevant Water Source.
Enter the corresponding Water Sub Source. This will map the water sub source to the specified water source.
Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.
Checklist
The checklist is a set of activities to be performed one the data is filled into a template to ensure data type, size, and format of data is as per the expectationentry requirements are met. These activities have been divided into 2 groups as given below.
Common Checklist
This checklist covers all the activities which are common across the entities.
Sr. No. | Checklist Parameter | Example |
|---|---|---|
1 | Make sure that each and every point in this reference list has been taken care of. |
Entity Specific Checklist
This checklist covers the activities which are specific to the entity.
Sr. No.
Checklist Parameter
Example
1
Water source and water sub source should follow parent child relationship
Water Source : Ground
Water Sub Source : Well
2
This data should be collected at ULB level
NA
Attachments
Separate Entity Specific Checklist is not required for this module data.