Introduction
Sewerage Charges are recurring charges which are levied on a pre-defined billing period. Billing period can be configurable as per the requirement. The rate for calculation of sewerage charges can vary widely and can be dependent upon various parameters. For eg. they can be dependent upon either plot size slab combined with property usage type or solely dependent upon property usage type. In some cases sewerage charges can also be levied as some percentage of water charges.
Data Table
Sr. No. | *Property Usage Type | *Flat fee (in Rs) |
---|---|---|
1 | Residential | 200 |
2 | Commercial | 500 |
Sr. No. | *Property Usage Type | *Property size slab from (units) | *Property size slab to (units) | *Rate (in Rs/units) |
---|---|---|---|---|
1 | Residential | 0 | 150 | 2 |
| Residential | 150 | 300 | 2.5 |
2 | Commercial | 0 | 150 | 4 |
| Commercial | 150 | 300 | 4.5 |
Sr. No. | *Percentage of water charges (%) |
---|---|
1 | 30 |
|
|
Procedure
Data Definition
Sr. No. : Defines the serial no of the line item.
Property usage type : Specifies the property usage type
Slab : From and to value for plot size
Flat fee: Flat sewerage charges collected based on property usage type
Rate : Consumption charges per unit corresponding to the usage type
Percentage of water charges : Percent value
Steps to fill this data
Get information about charges levied for sewerage connection as a part of bill
Get slab range and rate information for corresponding property usage type if applicable
Get percentage value for calculating sewerage charges based on water charges
Property usage type collected from State/ULB should be mapped with DIGIT property module
Validation
Data should be collected at ULB level
Attachments