Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 10 Next »

Introduction

Water Charges are levied for metered connections based on consumption. The rate for calculation of water charges can vary widely and can be dependent upon various parameters. In digit W&S, consumption charges defined are based on consumption combined with property usage type.

Data Table

Sr. No.

*Property Usage Type

*Water consumed value from (units)

*Water consumed value to (units)

*Rate (in Rs/ unit)

 1

Residential

 1

150

3

 2

Residential

 151

300

4

Note: Data given in the above table is a sample data.

Procedure

Data Definition

Sr. No.

Column Name

Data Type

Data Size

Mandatory

Description

1

Property usage type

Reference

 

Yes

Refer Usage Category Major

2

Slab (Water consumed)

Decimal

 

Yes

From and to value for water consumed

3

Rate

Decimal

 

Yes

Consumption charges per unit corresponding to the usage type

How to fill data

  1. Download the data template attached to this page.

  2. Get a good understanding of all the headers in the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.

  3. In case of any doubt, please reach out to the person who has shared this template with you to discuss and clear your doubts

  4. Get information about charges levied for metered connection as a part of bill

  5. Get slab range and rate information for corresponding property usage type

  6. Property usage type collected from State/ULB should be mapped with DIGIT property module

  7. Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.

Checklist

The checklist is a set of activities to be performed one the data is filled into a template to ensure data type, size, and format of data is as per the expectation. These activities have been divided into 2 groups as given below.

Common Checklist

This checklist covers all the activities which are common across the entities.

Sr. No.

Checklist Parameter

Example

1

Make sure that each and every point in this reference list has been taken care of.

Checklist

Entity Specific Checklist

This checklist covers the activities which are specific to the entity.

Sr. No.

Checklist Parameter

Example

1

Property usage type should be mapped to ontology present in property module

‘Domestic’ in W&S = ‘Residential’ in PT

2

Slab (Water consumed) should be a decimal value

1.24 : [Allowed]

1.24 kL. : [Not allowed]

Attachments

  1. Configuration data template - Water rates (metered)

2. Sample configuration data - Water rates (metered)

  • No labels