Introduction

The Property Sub Type represents 2nd level classification to the Property Type and provides the option to further classify the property type in sub types. For example property type ‘Built-up’ is further classified into Independent House, A Flat In Apartment and Half Constructed Half Open and considered differently on tax calculation procedure.

Data Table

Note: The data in the above table is sample data.

Procedure

Steps to fill data

1. Download the data template attached to this page.

2. Refer to the ‘Data Definition’ section of this document to understand the headers in the template sheet, their data type, size, and definitions.

3. Reach out the person who shared the template for further details or to clear your doubts. Identify if the State/ULB has a provision for capturing pipe size for connections.

4. Identify all the property sub types applicable and fill into the given template.

5. Go through the checklist to verify the data. Make sure that each and every point mentioned in the checklist is covered.

Checklist

The checklist is a set of activities to be performed one the data is filled into a template to ensure data type, size, and format of data is as per the expectation. These activities have been divided into 2 groups as given below.

Common Checklist

This checklist covers all the activities which are common across the entities.

Entity Specific Checklist

There is no separate checklist is applicable to this entity.

Attachments

1. Configurable Data Template - Property Sub Type

(Refer to “Property Sub Type Fee” tab in the attached file)

 

Open

1. Sample Configurable Data- Property Sub Type

 

Open