Introduction

Roads are constructed in order to facilitate the locomotion of people from a place to another.

The roads constructed in a state are classified into certain categories which could be on the basis of width of road, construction material or the function and location. Road type is one of factor defining the unit rates and hence configuration is needed for DIGIT module in order to describe the property and what are the taxes it could attract.

Data Table

Given below is the sample data table from the template in which the data has to be collected:

Please note that the values mentioned in the data table are sample values and the states are free to add/update according to there requirements.

Procedure

Data Definition

Steps to fill Data

1. Download the data template attached to this page.

2. Get a good understanding of all the headers in the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.

3. In case of any doubt, please reach out to the person who has shared this template with you to discuss and clear your doubts.

4. Firstly identify all the classifications of road types which are present in the state.

5. Secondly get the codes for that classification, if not present form the codes with abbreviated terms.

6. After which start filling the template with the proper codes and description.

7. Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.

Checklist

The checklist is a set of activities to be performed one the data is filled into a template to ensure data type, size, and format of data is as per the expectation. These activities have been divided into 2 groups as given below.

Common Checklist

This checklist covers all the activities which are common across the entities.

Entity Specific Checklist

Not Applicable

Attachments

Configuration Data Template - Road Type

Open

DIGIT Sample Configurable Data - Road Type

Open