Introduction
Sewerage Charges are recurring charges which are levied on a pre-defined billing period. Billing period can be configurable as per the requirement. The rate for calculation of sewerage charges can vary widely and can be dependent upon various parameters. For eg. they can be dependent upon either plot size slab combined with property usage type or solely dependent upon property usage type. In some cases sewerage charges can also be levied as some percentage of water charges.
Data Table
Sr. No. | *Property Usage Type | *Property size slab from (units) | *Property size slab to (units) | *Percentage of water charges (%) | *Flat fee (in Rs) | *Rate |
|---|---|---|---|---|---|---|
1 | Residential | 1 | 150 | 30 | 200 | 5 |
2 | Residential | 151 | 300 | 40 | 500 | 10 |
Note: Data given in the above table is a sample data.
Procedure
Data Definition
Sr. No. | Column Name | Data Type | Data Size | Mandatory | Description |
|---|---|---|---|---|---|
1 | Property usage type | Text | 64 | Yes | Refer to property usage type |
2 | Slab (Property size value) | Decimal | (10,2) | Yes | From and to value for property size |
3 | Flat fee | Decimal | (3,2) | Yes | Flat sewerage charges collected based on property usage type |
4 | Percentage of water charges | Decimal | (3,2) | Yes | Percent value |
5 | Rate | Decimal | (3,2) | Yes | Consumption charges per unit corresponding to the usage type |
Steps to fill this data
Download the data template attached to this page.
Get a good understanding of all the headers in the template sheet, their data type, size, and definitions by referring to the ‘Data Definition’ section of this document.
In case of any doubt, please reach out to the person who has shared this template with you to discuss and clear your doubts.
Get information about charges levied for sewerage connection as a part of bill
Get slab range and rate information for corresponding property usage type if applicable
Get percentage value for calculating sewerage charges based on water charges
Property usage type collected from State/ULB should be mapped with DIGIT property module
Verify the data once again by going through the checklist and making sure that each and every point mentioned in the checklist is covered.
Checklist
The checklist is a set of activities to be performed one the data is filled into a template to ensure data type, size, and format of data is as per the expectation. These activities have been divided into 2 groups as given below.
Common Checklist
This checklist covers all the activities which are common across the entities.
Sr. No. | Checklist Parameter | Example |
|---|---|---|
1 | Make sure that each and every point in this reference list has been taken care of. |
Entity Specific Checklist
Entity Specific Checklist is not required separately.
Attachments
Configuration data template - Sewerage rates
2. Sample configuration data - Sewerage rates